LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 366 (Manual Transaxle [Service, Removal & Installation G35M-R)) >> Vehicle Speedometer Sensor Removal/Installation (Without Abs)

Vehicle Speedometer Sensor Removal/Installation (Without Abs)

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the battery and battery tray.
  3. Remove the under cover.
  4. Disconnect the vehicle speedometer sensor connector.
  5. Remove the vehicle speedometer sensor.
  6. Apply transmission oil to a new O-ring and install it on a vehicle speedometer sensor.
  7. Install the vehicle speedometer sensor.

    Tightening torque 

    7.8-11.3 N.m 

    {80-115 kgf.cm, 69.5-99.8 in.lbf} 

  8. Connect the vehicle speedometer sensor connector.
  9. Install the under cover.
  10. Install the battery and battery tray.
  11. Connect the negative battery cable.
scientia non olet · About LEMON Manuals