Park Position Switch: Millenia
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, 2002 Mazda MX-5 Miata, and 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect negative battery cable. Remove rear console and center panel. Remove indicator screws and lift up panel. Disconnect park position switch connector. Check for continuity between terminals "K" and "H". See Fig 1 . Continuity should exist with switch released. Continuity should not exist with switch depressed. Replace switch as needed. See PARK POSITION SWITCH under REMOVAL & INSTALLATION.