PID/DATA Monitor Table
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
PID/DATA MONITOR CHART
| PID Name (Definition) | Unit/Condition | Condition/Specification | Action | ABS/TCS HU/ CM terminal |
|---|---|---|---|---|
| RPM (Engine speed signal input) | RPM |
|
Inspect PCM. (See PCM INSPECTION [L3] ) (See PCM INSPECTION [AJ] ) | - |
| CCNTABS (Number of continuous codes) | - |
|
Perform inspection using appropriate DTC. | - |
| PMPSTAT (Pump motor output state) | On/Off |
|
Inspect ABS/TCS HU/CM. (See ABS/TCS HU/CM SYSTEM INSPECTION ) | - |
| BOO_ABS (Brake pedal switch input) | On/Off |
|
Inspect brake switch. | - |
| ABS_LAMP (ABS warning light driver output state) | On/Off |
|
Inspect ABS warning light. | - |
| BRAKE_LMP (BRAKE system warning light output state) | On/Off |
|
Inspect BRAKE system warning light. | - |
| ABSRR_O (Right rear ABS pressure reduction solenoid valve output state) | On/Off |
|
Internal fault of ABS/TCS HU/CM. Replace ABS/TCS HU/CM. (See ABS/TCS HU/CM REMOVAL/INSTALLATION ) |
- |
| ABSLR_O (Left rear ABS pressure reduction solenoid valve output state) | On/Off |
|
Internal fault of ABS/TCS HU/CM. Replace ABS/TCS HU/CM. (See ABS/TCS HU/CM REMOVAL/INSTALLATION ) | - |
| ABSRF_O (Right front ABS pressure reduction solenoid valve output state) | On/Off |
|
Internal fault of ABS/TCS HU/CM. Replace ABS/TCS HU/CM. (See ABS/TCS HU/CM REMOVAL/INSTALLATION ) | - |
| ABSLF_O (Left front ABS pressure reduction solenoid valve output state) | On/Off |
|
Internal fault of ABS/TCS HU/CM. Replace ABS/TCS HU/CM. (See ABS/TCS HU/CM REMOVAL/INSTALLATION ) | - |
| ABSRR_I (Right rear ABS pressure retention solenoid valve output state) | On/Off |
|
Internal fault of ABS/TCS HU/CM. Replace ABS/TCS HU/CM. (See ABS/TCS HU/CM REMOVAL/INSTALLATION ) | - |
| ABSLR_I(Left rear ABS pressure retention solenoid valve output state) | On/Off |
|
Internal fault of ABS/TCS HU/CM. Replace ABS/TCS HU/CM. (See ABS/TCS HU/CM REMOVAL/INSTALLATION ) | - |
| ABSRF_I (Right front ABS pressure retention solenoid valve output state) | On/Off |
|
Internal fault of ABS/TCS HU/CM. Replace ABS/TCS HU/CM. (See ABS/TCS HU/CM REMOVAL/INSTALLATION ) | - |
| ABSLF_I (Left front ABS pressure retention solenoid valve output state) | On/Off |
|
Internal fault of ABS/TCS HU/CM. Replace ABS/TCS HU/CM. (See ABS/TCS HU/CM REMOVAL/INSTALLATION ) | - |
| ABSVLVRLY (Fail-safe relay output state) | On/Off |
|
Inspect ABS/TCS HU/CM. (See ABS/TCS HU/CM INSPECTION ) | - |
| ABSPMPRLY (Motor relay output state) | On/Off |
|
Inspect ABS/TCS HU/CM. (See ABS/TCS HU/CM INSPECTION ) | - |
| LF_WSPD (Left front ABS wheel-speed sensor input) | KPH, MPH |
|
Inspect ABS wheel-speed sensor/sensor rotor. | I, E |
| RF_WSPD (Right front ABS wheel-speed sensor input) | KPH, MPH |
|
Inspect ABS wheel-speed sensor/sensor rotor. | G, D |
| LR_WSPD(Left rear ABS wheel-speed sensor input) | KPH, MPH |
|
Inspect ABS wheel-speed sensor/sensor rotor. | C, F |
| RR_WSPD (Right rear ABS wheel-speed sensor input) | KPH, MPH |
|
Inspect ABS wheel-speed sensor/sensor rotor. | A, B |
| ABS_VOLT (System battery voltage value) | V |
|
Inspect power supply circuit. (See ABS/TCS HU/CM INSPECTION ) | Z |
| PCM_MSG (Missing message from the PCM) | Present/Not Present |
|
Inspect PCM. (See PCM INSPECTION [L3] ) (See PCM INSPECTION [AJ] ) Inspect ABS/TCS HU/CM. (See ABS/TCS HU/CM INSPECTION ) | - |
| TCM_MSG (Missing message from the TCM) | Present/Not Present |
|
Inspect TCM. (See TCM INSPECTION [FN4A-EL] ) (See TCM INSPECTION [AW6A-EL] ) Inspect ABS/TCS HU/CM. (See ABS/TCS HU/CM INSPECTION ) | - |