Balls, Inner Ring, Cage Disassembly Note

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Mark the inner ring and cage.
CAUTION:
- Mark with paint; do not use a punch.
Remove the snap ring using snap-ring pliers.
Turn the cage approximately 22.5 degree and pull the cage and balls away from the inner ring.

Fig 1: Turning Cage 22.5 Degree And Pulling Cage And Balls Away From Inner Ring
Courtesy of MAZDA MOTORS CORP.