Resistance Inspection
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Perform the following procedure only when directed.
- Turn the ignition switch to LOCK position.
- Disconnect the negative battery cable.
- Disconnect the fuel injector connectors.
- Measure the resistance of the fuel injector using an ohmmeter.
- If not as specified, replace the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION [L3] .)
- If as specified but "Operation Test" is failed, carry out the "Circuit Open/Short Inspection". Inspect for open or short circuit.
Resistance
11.4-12.6 ohms [20 °C {68 °F}]