Cooling Fan Motor Inspection: AJ
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the battery is fully charged. (See BATTERY INSPECTION .)
- Disconnect the fan control module connector (3 terminals).
- Connect the positive battery voltage and an ammeter to the fan control module connector on fan motor side. (2 terminals)
- Verify that the fan motor operates smoothly at the standard current draw.
- If not within the specification, replace the fan motor.
Standard current [12 V]
11.8-14.8 (A)
- Perform the same procedure as Step 2 for the cooling fan motor No. 2.