Evaporative system test procedure: Specification
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
PID SPECIFICATION
| PID | PID Range |
|---|---|
| BARO | 72.2 kPa {543 mmHg, 21.3 inHg} or more |
| FLI | 15-85% |
| IAT | 5-45°C {41-113 °F} |
| B+ | 11.0 V or more |
- 3. Start the engine.
- 4. Drive the vehicle or let the engine idle more than 20 min.
- 5. Turn ignition switch off, then turn it to the ON position again (Key On Engine Off).
- 6. Press the tick icon to start the test.
- 7. Verify that no DTCs present after the completion of the test.
- If any test result is indicated with red, diagnose the problem using the following DTC troubleshooting procedure or component inspection procedure.
- If any DTCs are detected, diagnose the problem using the appropriate DTC troubleshooting procedure.