LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 333 (On-Board Diagnostic (Engine Control System (L3)) >> On-Board Diagnostic Test >> On-Board System Readiness Tests Access Procedure

On-Board System Readiness Tests Access Procedure

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the necessary vehicle preparation and visual inspection.
  2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located at the left side of the center console.
  3. Monitor the OBD-II systems operating status by WDS or equivalent.
    Fig 1: Locating DLC-2 16-Pin Connector
    G03643421Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals