LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 333 (On-Board Diagnostic (Engine Control System (L3)) >> DTC P0328 >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0328 [L3] DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT KNOCK SENSOR CONNECTOR TERMINAL FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Disconnect knock sensor connector.
  • Inspect for poor connection at terminals A and B (such as damaged, pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair terminal, then go to step 7.
No Go to the next step.
4 INSPECT KNOCK SENSOR 
 Yes Go to the next step.
No Replace knock sensor, then go to step 7.
5 INSPECT KNOCK SIGNAL CIRCUIT FOR SHORT TO POWER SUPPLY 
  • Turn ignition switch ON (Engine off).
  • Measure voltage between knock sensor terminal A (harness-side) and body GND and knock sensor terminal B (harness-side) and body GND.
  • Is there any voltage?
 Yes Repair or replace harness for short to power supply, then go to step 7.
No Go to the next step.
6 INSPECT PCM CONNECTOR FOR POOR CONNECTION 
  • Disconnect PCM connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair or replace the terminal, then go to the next step.
No Go to the next step.
7 VERIFY TROUBLESHOOTING OF DTC P0328 COMPLETED 
  • Make sure to connect all disconnected connectors.
  • Turn ignition switch to ON (Engine off).
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start engine and warm it up completely.
  • Is same DTC present?
 Yes Replace PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
8 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection. (See DTC TABLE .)
No Troubleshooting completed.
(1) California emission regulation applicable ATX model
(2) Except for California emission regulation applicable ATX model
scientia non olet · About LEMON Manuals