Washer Hose Repair

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Locate and verify the leaking washer hose.

Fig 1: Removing Damaged Portion Of Washer Hose
Courtesy of MAZDA MOTORS CORP.
Cut the hose cleanly and remove the damaged portion of the washer hose.
Install a windshield washer hose adapter between the cut ends of the hose.
NOTE:
- In difficult cases, clamping may be required.
Install a segment of 6.4 mm (0.25 in) i.d. black rubber hose over the ends of the washer hose, and clamp both ends of the rubber hose using spring clamps.