Removal and Installation

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery ground cable. For additional information, refer to BATTERY DISCONNECT .

Fig 1: Removing Front Door Latch Release Handle Bezel
Courtesy of MAZDA MOTORS CORP.
Remove the front door latch release handle bezel.
1. Remove the screw.
2. Remove the front door latch release handle bezel.
  
  Fig 2: Removing Door Handle Cup Screw
  Courtesy of MAZDA MOTORS CORP.
Remove the door handle cup screw.

Fig 3: Removing Front Door Trim Panel
Courtesy of MAZDA MOTORS CORP.
Remove the front door trim panel.
1. Remove the screws.
2. Remove the front door trim panel and disconnect the electrical connector.
To install, reverse the removal procedure.