LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Controls - Removal, Overhaul & Installation) >> Fuel System >> Fuel Rails & Injectors >> Removal & Installation (Protege & 626 2.0L)

Removal & Installation (Protege & 626 2.0L)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2001 Mazda Tribute, 2001 Mazda Protege, 2001 Mazda Millenia, 2001 Mazda MX-5 Miata, and 2001 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . On Protege with 1.6L engine, release plastic fuel line coupler. See Figure. On all models, slide fuel line clamp back and disconnect fuel line. Disconnect injector electrical connectors. Remove injector harness from fuel rail. Remove fuel rail mounting bolts. Remove fuel rail, injectors and pressure regulator as an assembly.
  2. Remove insulators, injectors and "O" rings from fuel rail. To install, reverse removal procedure. Apply coat of engine oil to NEW "O" rings and install rings on injectors. Install NEW insulators. Tighten fuel rail mounting bolts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals