Removal & Installation (MPV)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2001 Mazda Tribute, 2001 Mazda Protege, 2001 Mazda Millenia, 2001 Mazda MX-5 Miata, and 2001 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.

CAUTION: Do not remove the IMRC cable bracket from the IMRC housing. Removing the IMRC bracket may cause poor engine running condition because the IMRC shutter valve angle will change.

Remove the IMRC actuator cable.

NOTE: Install the IMRC cable through the bottom of the pressure regulator.

Install in the reverse order of removal.

Fig 1: Identifying Camshaft Position (CMP) Sensor (B2300)

Courtesy of MAZDA MOTORS CORP.