LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Power Steering System) >> Power Steering Pump - 3.0L DURATEC (4V) >> Installation

Power Steering Pump - 3.0L DURATEC (4V): Installation

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Positioning Power Steering Pump
G01902345Courtesy of MAZDA MOTORS CORP.
  1. Position the power steering pump.
    Fig 2: Installing Power Steering Pump Bracket
    G01902346Courtesy of MAZDA MOTORS CORP.
  2. Install the power steering pump bracket.
    1. Install the five bolts.
    2. Install the six nuts.
    3. Install the pressure line bracket screw.
    Fig 3: Installing Engine Insulator
    G01902347Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • The engine isolator bracket is shown removed for clarity.
  3. Install the engine insulator.
    1. Install the bolts.
    2. Install the nut.
      Fig 4: Installing Upper Engine Insulator Bracket Bolt
      G01902348Courtesy of MAZDA MOTORS CORP.
  4. Install the upper engine insulator bracket bolt.
    Fig 5: Positioning A/C Line Support & Installing Nut
    G01902349Courtesy of MAZDA MOTORS CORP.
  5. Position the A/C line support and install the nut.
    Fig 6: Installing Ground Cable & Nut
    G01902350Courtesy of MAZDA MOTORS CORP.
  6. Install the ground cable and nut.
    Fig 7: Installing Seal On Power Steering Pressure Hose Fitting Using Tool
    G01902351Courtesy of MAZDA MOTORS CORP.
  7. Using the special tool, install a new seal on the power steering pressure hose fitting.
    • Remove and discard the original seal.
    • Stretch the seal over the special tool and slide it onto the tube nut.
      Fig 8: Connecting Power Steering Pressure Hose
      G01902352Courtesy of MAZDA MOTORS CORP.
  8. Connect the power steering pressure hose.
    1. Connect the power steering pressure hose to the pump.
    2. Connect the electrical connector.
    3. Install the power steering pressure line bracket bolt.
      Fig 9: Connecting Power Steering Low Pressure Hose
      G01902353Courtesy of MAZDA MOTORS CORP.
  9. Connect the power steering low pressure hose.
    Fig 10: Installing Power Steering Pump Pulley & Bolt
    G01902354Courtesy of MAZDA MOTORS CORP.
  10. Install the power steering pump pulley and bolt.
  11. Install the drive belt. .
    Fig 11: Tightening Power Steering Pump Pulley Bolt
    G01902355Courtesy of MAZDA MOTORS CORP.
  12. Tighten the power steering pump pulley bolt.
    Fig 12: Removing Special Tools
    G01902356Courtesy of MAZDA MOTORS CORP.
  13. Lower the vehicle and remove the special tools.
  14. Fill, bleed and leak check the power steering system. Refer to FILL  .
scientia non olet · About LEMON Manuals