Rear Antenna Feeder Inspection

WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Verify that there is no continuity between antenna feeder terminals A and B using an ohmmeter.
Inspect for continuity between the antenna feeder terminals using an ohmmeter.
- If not as specified, replace the rear harness.
Fig 1: Rear Antenna Feeder Terminals Continuity Chart
Courtesy of MAZDA MOTORS CORP.

Fig 2: Identifying Rear Antenna Feeder Terminals
Courtesy of MAZDA MOTORS CORP.