LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 284 (Exterior Trim) >> Extractor Chamber Removal/Installation

Extractor Chamber Removal/Installation

WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bumper. (See REAR BUMPER REMOVAL/INSTALLATION .)
  2. Remove the left side trunk side trim.
  3. Remove the screw.
  4. Squeeze the clips A and remove the extractor chamber from the vehicle side.
    Fig 1: Removing Extractor Chamber
    G01931193Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals