Operating inspection
WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the fan switch to OFF.
- Turn the mode dial to VENT.
- Turn the ignition switch to ON position. (engine ON)
- Turn the fan switch 4th position.
- Turn the mode dial from VENT to DEFROSTER.
- Verify that the airflow mode actuator moves smoothly.
- If not as specified, inspect the airflow mode main link and sub link for clogging and deformity.
- If the actuator cannot move at all, go to voltage inspection.