LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Controls - System & Component Testing) >> Fuel System >> Fuel Control >> Fuel Injector Volume (Miata, Protege, Protege5 & 626 2.0L)

Fuel Injector Volume (Miata, Protege, Protege5 & 626 2.0L)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, 2002 Mazda MX-5 Miata, and 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect battery. Remove fuel rail assembly and injectors from intake manifold. See REMOVAL, OVERHAUL & INSTALLATION article.
  2. Using mechanics wire, secure each fuel injector to fuel rail. Disconnect fuel injector connectors. Reconnect fuel lines to fuel rail.
  3. Using Special Service Tool (SST) 49-L018-901, connect battery to each injector in turn. Using a fused jumper wire, connect DLC-1 connector terminals F/P and GND. Turn ignition on for 15 seconds. Measure fuel injector output volume. See FUEL INJECTOR OUTPUT VOLUME SPECIFICATIONS  table. If fuel injector output volumn is not as specified, replace fuel injector.
  4. When all injectors have been checked, remove SST and reinstall all components. Check system for leaks.
scientia non olet · About LEMON Manuals