LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (Engine Mechanical (Service Information AJ)) >> Timing Chain Removal/Installation >> Camshaft Caps (LH) Removal Note

Camshaft Caps (LH) Removal Note

WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Remove the camshaft bearing thrust caps No. 1L and 6L first. Do not loosen any of the other bolts until the thrust caps are removed, or damage to the thrust caps may occur.
NOTE:
  • Cylinder head and the camshaft bearing caps are numbered to make sure they are assembled in their original position. When removed, keep the bearing caps with the cylinder head from where they were removed together. Do not mix the caps.
  1. Loosen bolts in several passes.
    NOTE:
    • Do not remove bolts completely.
  2. Remove the camshaft (LH) thrust caps 1L and 6L.
    Fig 1: Removing Sequence Of LH Camshaft Thrust Caps - 1L & 6L
    G01929645Courtesy of MAZDA MOTORS CORP.
  3. Loosen the remaining bolts 7-8 turns in the indicated sequence in Fig 2 to allow the camshaft (LH) to rise.
    Fig 2: Removing Sequence Of LH Camshaft Thrust Caps - All Remaining
    G01929646Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals