LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (Engine Mechanical (Service Information AJ)) >> Cylinder Head Gasket Replacement >> Cylinder Head (LH) Installation Note

Cylinder Head (LH) Installation Note

WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tighten the cylinder head bolts in the order shown in Fig 1 using the following 6 steps.
    1. Tighten to 32-38 N.m {3.3-3.8 kgf.m, 24-28 ft.lbf}  .
    2. Tighten 85°  -95°  .
    3. Loosen 360°  (one full turn) in reverse order.
    4. Tighten to 32-38 N.m {3.3-3.8 kgf.m, 24-28 ft.lbf}  .
    5. Tighten 85°  -95  °.
    6. Tighten 85°  -95°  .
    Fig 1: Tightening Sequence Of LH Cylinder Head Bolts
    G01929688Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals