Corner Seal Spring
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 Mazda RX-8, 2010 Mazda RX-8, 2009 Mazda RX-8, 2008 Mazda RX-8, and 2007 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Assemble the corner seal spring into the rotor.
- Assemble the corner seal into the rotor.
- Measure the corner seal projection using a vernier caliper.
- If it is less than the minimum specification, replace the corner seal spring.
Minimum Projection
- 0.5 mm {0.02 in}