Cut-Off Seal Spring Assembly Note

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 Mazda RX-8, 2010 Mazda RX-8, 2009 Mazda RX-8, 2008 Mazda RX-8, and 2007 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Assemble the cut-off seal spring with the spring end turned upward.
NOTE:
- When replacing a cut-off seal with a new one, assemble the seal with the pink surface facing upward.
Fig 1: Assembling Cut-Off Seal Spring With Spring End Turned Upward
Courtesy of MAZDA MOTORS CORP.