LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Engine Mechanical - Overhaul) >> Main Bearing Replacement >> Installation >> Standard Power

Standard Power

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 Mazda RX-8, 2010 Mazda RX-8, 2009 Mazda RX-8, 2008 Mazda RX-8, and 2007 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Temporarily assemble the stationary gear and the main bearing so that the main bearing tab and notch are aligned after pressing in the main bearing and stationary gear.
    Fig 1: Aligning Main Bearing Tab & Notch
    G02831013Courtesy of MAZDA MOTORS CORP.
  2. Remove the SST  handle.
    Fig 2: Removing SST Handle
    G02831014Courtesy of MAZDA MOTORS CORP.
    3. CAUTION:
    • Press the main bearing in so that the top of the main bearing is flush with the top of the stationary gear flange.
    Fig 3: Pressing Main Bearing
    G02831015Courtesy of MAZDA MOTORS CORP.
  3. Position the gear of the stationary gear downward, and install the main bearing by pressing it with the SST  .
scientia non olet · About LEMON Manuals