Engine Coolant Leakage Inspection
WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the coolant level. See ENGINE COOLANT LEVEL INSPECTION .
- Remove the radiator cap.
- Connect a radiator cap tester and the SSTs
to the radiator filler neck (FS) or reservoir filler neck (KL).
CAUTION:
- Applying more than 123 kPa {1.25 kgf/cm2 , 17.8 psi} can damage the hoses, fittings, and other components, and cause leaks.
- Apply pressure to the radiator.
Pressure 123 kPa {1.25 kgf/cm2 , 17.8 psi}
- Verify that the pressure is held.
- If not, inspect the system for coolant leakage.