Clutch Pipe Removal/Installation
WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- If any clutch pipe has been disconnected at any time during the procedure, add brake fluid, bleed the air, and inspect for leakage after the procedure has been completed.
- If removing the clutch pipe, remove it using the SST (49 0259 770B). If installing the clutch pipe, adjust the clutch pipe tightening torque to allow for the use of a torque wrench SST (49 0259 770B) combination, and then tighten the clutch pipe using the SST (49 0259 770B).