Flywheel Installation Note

1. Install the flywheel to the crankshaft.
2. When reusing the bolts, clean and apply sealant to the threads. (FS)
   NOTE:

   • No sealant is needed when using new bolts. (FS)
3. Hand-tighten the flywheel lock bolts.
4. Install the SST  to the flywheel.
5. Gradually tighten the flywheel lock bolts in a crisscross pattern.
   Fig 1: Flywheel Bolt Tightening Sequence

   Courtesy of MAZDA MOTORS CORP.

Tightening Torque 

FS:97-102 N.m {9.8-10.5 kgf.m, 71-75 ft.lbf} 

KL: 61-67 N.m {6.2-6.9 kgf.m, 45-49 ft.lbf}