Manual Transaxle Removal/Installation: Notes
WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery, and battery box.
- Remove the fresh air duct and air cleaner component.
- Remove the wheels and tires.
- Remove the splash shields.
- Drain the transaxle oil into a container.
- Remove the starter for FS engine. See STARTER .
- Remove in the order indicated in the table.
- Install in the reverse order of removal.
- Add the specified amount of the specified transaxle oil. See TRANSAXLE OIL REPLACEMENT .
- Warm up the engine and transaxle, inspect for oil leakage, and inspect the transaxle operation.