Vehicle Speedometer Sensor Removal/Installation
WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the battery component.
- Remove the air cleaner component.
- Disconnect the vehicle speedometer sensor connector.
- Remove the vehicle speedometer sensor.
- Apply ATF to a new O-ring and install it on a new vehicle speedometer sensor.
- Install the vehicle speedometer sensor.
Tightening Torque
7.9-10.7 N.m {80-110 kgf.cm, 69.5-95.4 in.lbf}
- Connect the vehicle speedometer sensor connector.
- Install the battery component.
- Install the air cleaner component.
- Connect the negative battery cable.