Transaxle Fluid Temperature (TFT) Sensor Removal/Installation
WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- When the transaxle and ATF are hot, they can cause severe burns. Turn off the engine and wait until they are cool before performing this procedure.
- Remove the control valve body cover. See CONTROL VALVE BODY REMOVAL/INSTALLATION .
- Disconnect the TFT sensor connector.
- Remove the TFT sensor.
- Install a TFT sensor.
Tightening Torque
6.5-7.8 N.m {66-80 kgf.cm, 58-69 in.lbf}
- Connect the TFT sensor connector.
- Install the control valve body cover. See CONTROL VALVE BODY REMOVAL/INSTALLATION .
- Carry out the line pressure test. See LINE PRESSURE TEST .