LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Automatic Transaxle - Service, Removal & Installation [GF4A-El]) >> Oil Seal Removal/Installation

Oil Seal Removal/Installation

WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive shaft and joint shaft. See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION .
  2. Remove and discard the oil seal using a screwdriver.
  3. Tap the new oil seal into the transaxle case using the SST  .
    Fig 1: Installing New Oil Seal
    G01137190Courtesy of MAZDA MOTORS CORP.
  4. Install the drive shaft and joint shaft. See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION .
  5. Using the SST  and a hammer, tap the new oil seal in evenly until the SST  contacts the transaxle case.
  6. Coat the lip of the oil seal with ATF.
scientia non olet · About LEMON Manuals