Oil Cooler Installation Note
WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- Automatic transaxle oil cooler flushing must be performed whenever a transaxle is removed for service to remove existing fluid which may be contaminated and to prevent contamination of new fluid. The flushing must be performed after installing the overhauled transaxle.
- Follow the manufacture's instructions for flushing the automatic transaxle oil cooler.
- Align the marks, and slide the oil hose onto the oil pipe until it is full seated as shown.