LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Automatic Transaxle - Service, Removal & Installation [GF4A-El]) >> O/D Off Switch Removal/Installation

O/D Off Switch Removal/Installation

WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the front console.
  3. Remove the indicator panel installation screws.
  4. Disconnect the connector and remove the O/D OFF switch terminals.
  5. Remove the selector lever knob component.
  6. Install a new selector lever knob component.

    Tightening Torque 

    2.0-2.9 N.m {20-30 kgf.cm, 18-26 in.lbf} 

  7. Install the O/D OFF switch terminals and connect the connector.
  8. Install the indicator panel installation screws.
  9. Install the front console.
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals