LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Automatic Transaxle - Service, Removal & Installation [GF4A-El]) >> Input/Turbine Speed Sensor Removal/Installation

Input/Turbine Speed Sensor Removal/Installation

WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the resonance chamber, fresh-air duct, and air cleaner component.
  3. Remove the fuel filter mounting nuts.
  4. Disconnect the input/turbine speed sensor connector.
  5. Remove the input/turbine speed sensor.
    Fig 1: Removing Input/Turbine Speed Sensor
    G01137145Courtesy of MAZDA MOTORS CORP.
  6. Apply ATF to a new O-ring and install it on a new input/turbine speed sensor.
  7. Install the input/turbine speed sensor.

    Tightening Torque 

    7.9-10.7 N.m {80-110 kgf.cm, 69.5-95.4 in.lbf} 

  8. Connect the input/turbine speed sensor connector.
  9. Install the fuel filter mounting nuts.
  10. Install the air cleaner component, fresh-air duct, and resonance chamber.
  11. Connect the negative battery cable.
scientia non olet · About LEMON Manuals