Tie-Rod End Removal Note

WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

The sharp edges of the SST can slice the tie-rod end dust boot. Install the SST so that the sharp edges are between the dust boot and the knuckle.

Remove the cotter pin and nut.

Fig 1: Using SST To Remove Tie-Rod End From Knuckle
Courtesy of MAZDA MOTORS CORP.
Disconnect the tie-rod end from the knuckle using the SST .