LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Automatic Transaxle - Service, Removal & Installation [La4A-El]) >> Turbine Shaft Speed Sensor Removal/Installation

Turbine Shaft Speed Sensor Removal/Installation

WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the wheel and tire, driver's side.
  3. Remove the splash shield.
  4. Disconnect the turbine shaft speed sensor connector.
  5. Remove the turbine shaft speed sensor.
  6. Apply ATF to a new O-ring and install it on a new turbine shaft speed sensor.
  7. Install the turbine shaft speed sensor.

    Tightening Torque 

    12.1-13.9 N.m {123-142 kgf.cm, 107-123 in.lbf} 

  8. Connect the turbine shaft speed sensor connector.
  9. Install the splash shield.
  10. Install the wheel and tire, driver's side.
  11. Connect the negative battery cable.
scientia non olet · About LEMON Manuals