LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 247 (Seat Belt System) >> Lock Release Solenoid Inspection

Lock Release Solenoid Inspection

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the rear door lower trim. (See REAR DOOR LOWER TRIM REMOVAL/INSTALLATION .)
  3. Disconnect the lock release solenoid connector.
  4. Measure the resistance of the lock release solenoid individually.
    • If not within the specification, replace the front seat belt.

    Standard 54-66 ohms 

    Fig 1: Measuring Resistance Of The Lock Release Solenoid
    G01346291Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals