Front Buckle Switch Inspection: Passenger-Side

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Disconnect the buckle switch connector.
Verify continuity as indicated. See Fig 1.
- If not as indicated, replace the front buckle.
Fig 1: Continuity Check Between Terminals Of Connector
Courtesy of MAZDA MOTORS CORP.

Fig 2: Checking Continuity Between Terminals Of Connector
Courtesy of MAZDA MOTORS CORP.