Fuel Tank Side (Except For Fuel Shut-Off/Rollover Valve): Removal

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Follow the before repair procedure and perform the fuel line safety procedure. (See BEFORE REPAIR PROCEDURE .)
CAUTION:
- The quick release connector may be damaged if the release tab is bent excessively. Do not expand the release tab over the stopper.
NOTE:
- The fuel hose may be removed easily by rotating the release tab while the fuel hose is slightly pressed to fuel pipe side.
Rotate the quick release connector release tab to the stopper position.

Fig 1: Rotating Quick Release Connector Release Tab
Courtesy of MAZDA MOTORS CORP.
Pull out the fuel hose straight from the fuel pipe and disconnect it.

Fig 2: Disconnecting Fuel Hose From Fuel Pipe
Courtesy of MAZDA MOTORS CORP.
Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from being scratched or contaminated with foreign material.

Fig 3: Wrapping Disconnected Quick Release Connector & Fuel Pipe With Vinyl Sheeting
Courtesy of MAZDA MOTORS CORP.
NOTE:
- Take care not to damage or soil the fuel hose.