LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (Interior Trim) >> Glove Compartment Removal/Installation

Glove Compartment Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull the stay damper in the direction shown in the figure, and detach the connecting part between the glove compartment and the stay damper.
    Fig 1: Pulling Out Stay Damper
    G01344489Courtesy of MAZDA MOTORS CORP.
  2. Press the stopper in and remove it.
  3. Lower the glove compartment.
  4. Detach the clips from the dashboard and remove the glove compartment.
  5. Install in the reverse order of removal.
    Fig 2: Removing/Installing Glove Compartment
    G01344490Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals