Steering Shaft Installation Note
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the tilt lever is in the LOCK position.
- Temporarily tighten nuts A and B as shown in the figure.
- Tighten the nuts to the specified torque in the order of A, B.
Tightening torque
15.7-22.5 N.m
{1.60-2.29 kgf.m, 11.6-16.5 ft.lbf}