Steering Gear & Linkage Installation Note
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Temporarily tighten the bolts.
- Tighten the steering gear and linkage installation bolts to the specified torque in the order shown in the figure.
Tightening torque
74.4-104.8 N.m
{7.59-10.68 kgf.m, 54.88-77.29 ft.lbf}
- After connecting the connector, fix the wiring harness with the bands as shown in the figure.