LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Exterior Trim) >> Front BELTLINE Molding Removal/Installation

Front BELTLINE Molding Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the screw.
  2. Pull front beltline molding up, then remove it.
    Fig 1: Removing/Installing Front Beltline Molding
    G02563919Courtesy of MAZDA MOTORS CORP.
  3. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals