Oil Filter Replacement

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Remove the oil filter using the filter wrench.

Fig 1: Removing Oil Filter
Courtesy of MAZDA MOTORS CORP.
Use a clean rag to wipe off the mounting surface on the oil cooler.
Apply clean engine oil to the O-ring of new oil filter.
Install the oil filter until the O-ring contacts the sealing surface of the oil cooler.

CAUTION:

In case you spill engine oil on the protector under the filter, wipe it off cleanly. If you fail to wipe the spilled oil, it will produce a white fume because of the heat.

Tighten the filter 3/4 turns using the filter wrench.
Start the engine and inspect for oil leakage.
Inspect the oil level.
- Add oil if necessary. (See ENGINE OIL LEVEL INSPECTION .)