Secondary Coil Winding

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the ignition coil connector.
Remove the ignition coil. (See IGNITION COIL REMOVAL/INSTALLATION .)
Measure the resistance using an ohmmeter as shown in the figure:
- If not as specified, replace the ignition coil.
Resistance (Reference)

5.0-6.0 kilohms [25 °C {77°F}]

Fig 1: Measuring Resistance Of Secondary Coil Winding Using Ohmmeter
Courtesy of MAZDA MOTORS CORP.