Airflow Inspection

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Perform the following test only when directed.

Disconnect the negative battery cable.
Remove the purge solenoid valve. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION .)
Inspect airflow between the ports under the following conditions.
- If not as specified, replace the purge solenoid valve.
- If as specified, carry out the "Circuit Open/Short Inspection".
Fig 1: Testing Purge Solenoid Valve
Courtesy of MAZDA MOTORS CORP.

Fig 2: Identifying Purge Solenoid Valve Ports & Terminals
Courtesy of MAZDA MOTORS CORP.