Rear Airflow Mode And Air Mix Actuator Inspection

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Connect battery positive voltage to terminal G and ground to terminal F, and battery positive voltage to terminal F and ground to terminal G of the rear airflow mode and air mix actuator.

Fig 1: Inspecting Rear Airflow Mode And Air Mix Actuator
Courtesy of MAZDA MOTORS CORP.
Verify that the rear airflow mode and air mix actuator operates as shown below.

Fig 2: Connection/Movement Verification Of Rear Airflow Mode And Air Mix Actuator
Courtesy of MAZDA MOTORS CORP.

Fig 3: Inspecting Hot And Cold Ranges Of Rear Airflow Mode And Air Mix Actuator
Courtesy of MAZDA MOTORS CORP.
Inspect for continuity between the rear airflow mode and air mix actuator terminals using an ohmmeter.
- If not as specified, replace the rear airflow mode and air mix actuator.
  
  Fig 4: Rear Airflow Mode And Air Mix Actuator Terminal Connector Table
  Courtesy of MAZDA MOTORS CORP.