Inspection of Individual Part

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Remove the VSS sensor. (See VEHICLE SPEEDOMETER SENSOR (VSS) INSPECTION .)
Measure resistance between the terminals of the VSS speed sensor.
- If not as specified, replace the VSS sensor.
- If it is normal, replace the harness.
Resistance (ATF temperature: 20°C (68°F))

513-627 ohms

Fig 1: Measuring Resistance Between Terminals Of The VSS Speed Sensor
Courtesy of MAZDA MOTORS CORP.
Install the VSS sensor. (See VEHICLE SPEEDOMETER SENSOR (VSS) INSPECTION .)