Transaxle Fluid Temperature (TFT) Sensor Removal/Installation
WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION .)
- Disassemble the automatic transaxle, and then remove the TFT SENSOR.
- Install the TFT SENSOR, and then assemble the automatic transaxle.
- Install the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION .)
- Carry out the line pressure test. (See LINE PRESSURE TEST .)
- Inspect the operation of the TR switch. (See TRANSAXLE RANGE (TR) SWITCH INSPECTION .)
- Inspect the operation of the selector lever. (See SELECTOR LEVER INSPECTION .)
- Carry out the mechanical system test. (See MECHANICAL SYSTEM TEST .)
- Carry out the road test. (See ROAD TEST .)