Inspection of Individual Part

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Remove the intermediate sensor. (See INTERMEDIATE SENSOR INSPECTION .)
Measure resistance between the terminals of the intermediate speed sensor.
- If not as specified, replace the intermediate sensor.
- If it is normal, replace the harness.
Resistance (ATF temperature: 20°C (68°F))

513-627 ohms
Install the intermediate sensor. (See INTERMEDIATE SENSOR INSPECTION .)

Fig 1: Measuring Resistance Between Terminals Of Intermediate Speed Sensor

Courtesy of MAZDA MOTORS CORP.