Inspection of Individual Part

WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Remove the input/turbine speed sensor. (See INPUT/TURBINE SPEED SENSOR INSPECTION .)
Measure resistance between the terminals of the input/turbine speed sensor.
- If not as specified, replace the input/turbine speed sensor.
- If it is normal, replace the harness.
Resistance (ATF temperature: 20°C (68°F))

513-627 ohms

Fig 1: Measuring Resistance Between Terminals Of Input/Turbine Speed Sensor
Courtesy of MAZDA MOTORS CORP.
Install the input/turbine sensor. (See INPUT/TURBINE SPEED SENSOR INSPECTION .)